Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Power Up Procedures
When power is applied to the printer, the POWER LED switch (see previous page)
illuminates in green.
1. If the LED is not lit, press the POWER LED switch for approximately 1 second
and release the switch. This initiates the printer's power up cycle. During this
power up cycle, it is not possible to turn the power off.
2. When the printer has completed its power up cycle, the Off button (i.e., power
down button) appears in the lower-right side of the TDU. This allows you to
turn the printer off.
Note: The Off button is also referred to as the Soft Power switch. See
Figure
3-3.
Important Note: The Off button appears only when the printer is in one of the
following states (as shown in the example below):
Online Idle
Offline Idle
Offline Print
In other conditions, the Off button is not available (i.e., it does not appear). In
order to power down the printer, you must place the printer in one of these
conditions (Online Idle, Offline Idle, Offline Print).
Rev: 1
Figure 3-4. Offline Idle.
Page 3-5
of 32 pages
Chapter 3: Printer Operation
April, 2014
Advertisement
Table of Contents
