Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Print Width
The Print Width setting specifies, in inches, the print width of the document to be
printed.
Note: The Print Width setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Print Width function.
2. Press Enter, which causes the following Print Width screen to display:
Current
print
width
Note:
Pressing UN permits changing the units and all associated numeric data to
any one of the following:
inches
-
mm
-
7,200/Inch
-
Scan lines
-
Dots 1/400
-
Pressing CL after entering numeric data deletes 1 digit each time pressed.
3. The print width can be either increased or decreased in 0.1000" increments,
from a minimum of 5.0000" to a maximum of 17.0000".
Rev: 1
Figure 6-57. Print Width screen.
Page 6-73
of 128 pages
Chapter 6: Supervisory Functions
April, 2014
Advertisement
Table of Contents
