LP 100R Laser Printer Operator's Guide
Interface Setup Function
This function controls the operation of the printer's host communication interfaces
(RS-232, Parallel, and Ethernet).
Interface Setup Function Access
The Interface Setup menu, which controls the operation of communications
interfaces, displays all interfaces supported by the LP 100R printer regardless of
whether each interface is installed. If you configure an interface that is not
installed, the change will not affect the operation of the printer; but if that
interface is installed at a later date, it may not work correctly.
Note: Interface settings can not be changed when a print job is in progress.
1. Press the Up or Down triangle when the Supervisor Menu displays to move
the selection bar to the Interface Setup function.
2. Press Enter, which causes the following Interface Setup menu to display:
3. The functions that can be selected from the Interface Setup menu include:
RS-232
Parallel
Ethernet
Note: To print a copy of the interface settings installed in your printer, see the
procedure for printing a Status Page contained on
Rev: 1
Figure 6-19. Interface Setup menu.
Page 6-25
of 128 pages
Chapter 6: Supervisory Functions
page
3-26.
April, 2014