Vertical Adjustment; When A Print Job Is In Progress - SATO LP 100R Operator's Manual

LP 100R Laser Printer Operator's Guide

Vertical Adjustment

The Vertical Adjustment setting specifies the distance from the top of the form to
the top of the print area in either inches, mm, 7200/inch, scan lines, or DPI (dots
per inch) as defined by the Unit Field.
Note:
The Vertical Adjustment setting can be changed when either a print job is in

progress or the printer is idle.
If the Vertical Adjustment is changed, the software automatically stores the

change negating the need to execute the Store function.

When a Print Job Is in Progress

1. Press the OFFLINE switch, which causes the following Offline Print menu to
display:
Note: The system has switched from the Online Print mode to the Offline Print
mode.
Rev: 1
Figure 6-60. Offline Print menu.
Page 6-79
of 128 pages
Chapter 6: Supervisory Functions
April, 2014