Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
3. Press the Up or Down triangle to move the selection bar to the desired AIDC
Mode setting:
•
Enabled (Standard Mode) – Constantly monitors every printed page and
automatically adjusts the image density.
•
Disabled (No Toner Mark is displayed) – Prints the data as is without
checking the image density.
•
Power On (No Toner Mark is displayed) – The printer checks print
quality and makes adjustments to match the selected ID. These settings
are used until the next Power On.
•
Job Start (No Toner Mark is displayed) – Checks and adjusts the
image density at the beginning of each new job.
•
Form End (No Toner Mark is displayed) – Checks and adjusts the
image density at the start of each new job.
4. Press Enter to save the AIDC Mode Setting selected.
Note:
Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see
Rev: 1
page
6-63).
Page 6-128
of 128 pages
Chapter 6: Supervisory Functions
April, 2014
Advertisement
Table of Contents
