Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Modify Vertical Fine Adjustment
The Modify Vertical Fine Adjustment function, which specifies the distance from the
top of the form to the top of the print area, is accessed either by selecting
Vertical Fine Adjustment from the Print Alignment menu or by selecting
Vertical Fine Adj. from the Operator Express menu.
Selecting this function from either menu causes the following screen to display:
Current
vertical
adjustment
Vertical Fine Adjustment Menu Buttons
Button
Home
Back
1. Press Up to select a higher value or press Down to select a lower value.
Note:
You can also enter the desired value on the numeric keypad.
To enter a negative value, enter the value and then press the Minus (-)
key.
2. Press Enter to store the new setting and return the system to the Operator
Express menu.
Rev: 1
Figure 3-14. Modify Vertical Fine Adjustment.
Function
Press Home to return the system to the Exit Menu System
screen.
Press Back to return the system to the Exit Menu System
screen if this function was accessed from that screen.
If this function was accessed from the Operator Express
menu, press Back to return the system to the Main menu.
Page 3-21
of 32 pages
Chapter 3: Printer Operation
April, 2014
Advertisement
Table of Contents
