Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Swing Mode (Optional Unit)
The swing guide assists the smooth fanfolding of continuous forms as they are fed
out of the printer. It is accessed by means of the Swing Mode screen. The swing
guide can NOT be used with a page length that is less than 7" or greater
than 12".
When the Swing Mode is enabled, the TDU will display a prompt requesting the
orientation (in or out) of the fanfold when either loading forms or recovering from
a paper jam.
When a current configuration is changed to enable or disable the swing guide, the
following message appears if paper has not already been unloaded from the
printer:
Unload/Reload Forms to Change Swing Guide Status
If this message appears, the printer will not continue loading or changing the
configuration until the unload/reload procedure has been completed. At this point
the printer will continue to service your request.
To avoid this message, prior to changing the configuration, unload the current
stock and reload the printer with the next stock. The configuration change will be
completed without delay.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Swing Mode function.
2. Press Enter, which causes the following Swing Mode screen to display:
Rev: 1
Figure 6-83. Swing Mode screen.
Page 6-116
of 128 pages
Chapter 6: Supervisory Functions
April, 2014
Advertisement
Table of Contents
