LP 100R Laser Printer Operator's Guide
Up-Time
The sets the up-time clock to the length of time that power to the printer has been
turned on. It is expressed as either HH:MM:SS if less than 24 hours, or
DDD:HH:MM if more than 24 hours.
Note: Up-Time cannot be changed. It is, however, negated when power to the
printer is turned off.
1. Press the Up or Down triangle on the Supervisor Menu to move the selection
bar to the Time function.
2. Press Enter, which causes the following Time menu to display:
3. Press the Up or Down triangle to move the selection bar to the Up-Time
function.
4. Press Enter, which sets the Up-Time clock and returns the system to the
Supervisor Menu.
Rev: 1
Figure 6-33. Time menu.
Page 6-45
of 128 pages
Chapter 6: Supervisory Functions
April, 2014