Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Top Panel Switch LED Functions
Switch
POWER LED
(green)
PAUSE LED
(amber)
ALARM LED
(red)
OFFLINE
ONLINE
DOWN
FEED
CUT
RETURN
Rev: 1
Description
Illuminates continuously as a solid green light when the
printer is powered up.
Used to power up the printer.
When on, this switch invokes the Soft Power circuit,
which cycles power to the printer.
Illuminates as a solid amber light (along with the green
POWER LED) whenever the printer is in either the
Offline Idle or Offline Print mode.
Extinguishes when the printer is in either the Online Idle
or Online Print mode.
Displays as either a blinking red light or a solid red light
(along with the green POWER LED) when any of the
following conditions are detected:
If a Warning message displays on the TDU, the ALARM
LED displays as a blinking red light. Processing,
however, is not terminated.
See
page 5-17
for a list of Warning messages.
If either a Recoverable or Fatal error is detected,
processing is terminated. The ALARM LED displays as a
solid red light, the PAUSE LED displays as a solid
amber light, the POWER LED displays as a solid green
light, and the audible alarm sounds. An application error
message also displays on the TDU.
See
page 5-18
for a list of Operator Recoverable errors.
See
page 5-20
for a list of Fatal errors.
Important Note: Pressing the BEEP button on the TDU
turns off the audible alarm.
Stops the print cycle
Resumes the print cycle
Stacker table lowers while this switch is held down.
This switch is available in either the Online or Offline
mode.
Feeds one page each time it is pressed.
This switch is available only in the Offline mode.
If the burster unit is not installed, the printer will feed,
fuse, and drop the last printed page onto the stacker
table, thus permitting the operator to separate the last
printed page at the end of page perforation.
If the burster unit (optional component) is installed, the
printer feeds, fuses, and drops the last printed page
onto the stacker table where it is automatically cut off at
the end of page perforation.
This switch is available only in the Offline mode.
When pressed after the form has been cut, the form
returns to the top-of-form (TOF) position in order to
resume the Print function.
This switch is available only in the Offline mode.
Page 2-5
of 12 pages
Chapter 2: Printer Components
April, 2014
Advertisement
Table of Contents
