LP 100R Laser Printer Operator's Guide
Burster Mode (Optional Component)
If the Burster Mode is Enabled, when it receives the Cut command at the end of
the print job it will automatically cut the last printed page (at the end of page
perforation) and then drop it onto the stacker table.
Note: The Burster Mode setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Burster Mode function.
2. Press Enter, which causes the following Burster Mode screen to display:
Note:
Brackets ( [ ] ) around a specific Burster Mode setting indicate that it is the
Default Burster Mode setting.
An arrow () pointing to a specific Burster Mode setting indicates that it is
the setting assigned to the current configuration.
Rev: 1
Figure 6-85. Burster Mode screen.
Page 6-120
of 128 pages
Chapter 6: Supervisory Functions
April, 2014