Table of Contents
Advertisement
LP 100R Laser Printer Operator's Guide
Manufacturer's Instructions
The user must observe the following precautions in installing and operating this
device:
1. Operate the equipment in strict accordance with the manufacturer's
instructions for the model.
2. Plug the printer into a properly grounded wall outlet and use, unmodified, the
power cord supplied with the unit.
3. Always operate the printer with all factory-installed covers on the unit.
4. Make no modification to the equipment that would affect its meeting the
specified limits of the FCC Rules.
5. Maintain the equipment in a satisfactory state of repair.
6. Use a shielded and properly grounded I/O cable to ensure compliance of this
unit to the specified limits of the FCC Rules.
User's Responsibility
The user is ultimately responsible for correcting problems arising from harmful
radio frequency emissions from equipment under his or her control. If this
equipment does cause interference to radio or television reception (which as
specified can be determined by turning the printer off and on), SATO encourages
the user to try to correct the interference by changing one of the following:
Equipment orientation
Equipment location
Power source
All of these responsibilities and any others not mentioned are exclusively at the
user's expense.
If necessary, the user should consult SATO for additional suggestions.
Note: If it is determined that equipment operation is causing harmful interference,
the equipment operator may be required to stop operating the equipment until the
interference problem is corrected.
Rev: 1
Chapter 1: General Information
Page 1-5
of 6 pages
April, 2014
Advertisement
Table of Contents
