LP 100R Laser Printer Operator's Guide
System Start-up Procedures
1. If the POWER LED is not illuminated, press the POWER LED switch to power
up the printer. (See
2. If no paper stock has been loaded into the printer, the audible alarm sounds,
and the following screen displays:
Figure 3-6. No paper stock loaded – BEEP button shown.
3. Press the BEEP button once to turn off the audible alarm, and see the
document loading procedures starting on
4. If stock has been loaded into the printer, the controller will cycle through its
self-test, load the system software, print fonts, logos, default configuration
data, and cause the system start-up screen shown on
Rev: 1
Figure
3-2.)
page
Page 3-10
of 32 pages
Chapter 3: Printer Operation
3-30.
page 3-11
to display.
April, 2014