Supervisor Responsibilities; Appendix A: Installing System Software; Appendix B: Managing Files - SATO LP 100R Operator's Manual

LP 100R Laser Printer Operator's Guide

Supervisor Responsibilities

The supervisor is directly responsible for the creation and/or maintenance of the
configurations stored on the hard drive of the controller. These include:
Test Prints

Interface Setup

Configuration (Recall, Store, Remove, Edit)

Files

Password Enable/Change

Time

Procedures relative to all of the above, excluding Files, are included in
Chapter 6: Supervisory
The Files procedures are included in the following appendices.

Appendix A: Installing System Software

This appendix explains how to install the operating software for the LP 100R and
how to copy and/or install the various files used by the printer to control printer
operations, including the following:
System Program

System Menu

User's Configurations

System Setup


Appendix B: Managing Files

This appendix discusses the following:
 System Error Log
 Capture
It also explains how to store fonts, logos, and formats on the controller's hard
drive in either of the following directories:
Active directory (one for each type of file) – which contains the files that are

available to an application when the printer is started
Archive directory (one for each type of file) – which contains files that are not

available
Once stored on the hard drive, files can be:
Moved back and forth between the active and archive directories

Copied from the printer's diskette drive to either directory

Deleted from either directory

Note: If password protection has been enabled, none of the direct

responsibilities attributed to the supervisor can be accessed until the correct
password is entered.
Rev: 1
Functions.
Page 3-8
of 32 pages
Chapter 3: Printer Operation
April, 2014