LP 100R Laser Printer Operator's Guide
Image Density
The Image Density setting specifies the relative darkness of the image produced
by the printer. The higher the value specified, the darker the image.
Note: The Image Density setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Image Density function.
2. Press Enter, which causes the following Image Density screen to display:
Note:
•
Brackets ( [ ] ) around a specific density indicate that it is the Default
Configuration Image Density.
•
An arrow () pointing to a specific density indicates that it is the density
assigned to the currently displayed configuration.
Rev: 1
Figure 6-68. Image Density screen.
Page 6-87
of 128 pages
Chapter 6: Supervisory Functions
April, 2014