Emulation - SATO LP 100R Operator's Manual

LP 100R Laser Printer Operator's Guide

Emulation

The Emulation setting is the interpretation of the commands contained in the data
stream received by the Data Communication Port.
Note: The Emulation setting can not be changed when a print job is in progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Emulation function.
2. Press Enter, which causes the following Emulation screen to display:
3. The following functions can be selected from the Emulation screen:
Kodescript

Hex Dump

Line Printer

KodescriptPlus

HP PCL5e

IBM 5256

IGP/PGL

IGP/VGL

IPDS (optional)

Rev: 1
Figure 6-71. Emulation screen.
Page 6-93
of 128 pages
Chapter 6: Supervisory Functions
April, 2014