Removing The 2X 3.5-Inch Hdd Extension Box; Removing The Slimline Odd And Lsd Module From The Defective Hdd Extension Box; Installing The Slimline Odd And Lsd Module Into The New Hdd Extension Box; Installing The 2X 3.5-Inch Hdd Extension Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

7.4.4.3

Removing the 2x 3.5-inch HDD extension box

Ê Unlock and pull the 2x 3.5-inch HDD extension box out of its installation bays
as described in section
page 311.
7.4.4.4 Removing the slimline ODD and LSD module from the defective
HDD extension box
Ê If applicable, remove the slimline ODD from the defective 2x 3.5-inch HDD
extension box as described in section
extension box" on page
Ê If applicable, remove the LSD module from the defective 2x 3.5-inch HDD
extension box as described in section
extension box" on page
7.4.4.5 Installing the slimline ODD and LSD module into the new HDD
extension box
Ê If applicable, reinstall the slimline ODD into the new 2x 3.5-inch HDD
extension box as described in section
extension box" on page
Ê If applicable, install the LSD module into the new 2x 3.5-inch HDD extension
box as described in section
extension box" on page
7.4.4.6

Installing the 2x 3.5-inch HDD extension box

Ê Install the new 2x 3.5-inch HDD extension box as described in section
"Installing the 2x 3.5-inch HDD extension box" on page
7.4.4.7

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
TX300 S7 / RX350 S7
"Removing the 2x 3.5-inch HDD extension box" on
669.
672.
657.
"Installing the LSD module into the HDD
662.
379.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Removing the slimline ODD from the
"Removing the LSD module from the
"Installing the slimline ODD into the
"Installing the system
"Installing the system air duct"
302.
319