Adjusting The Position Of The; Releasing Solenoid; Adjusting The Pressure Of The Multifeeder Separation Roller; Releasing Solenoid (Sl5) - Canon 1000 Service Manual

13 Adjusting the Pressure of the
Multifeeder Separation Roller
If double-feeding or pick-up faults occur during
pick-up operation, change the position of the pres-
sure spring [2] of the separation roller [1].
a. If double-feeding occurs, move the spring
holder in the direction of A. (decrease the pres-
sure)
b. If pick-up faults occur, move the position of the
spring holder in the direction of B. (increace the
pressure)
[2]
Figure 7-256
14

Adjusting the Position of the

Multifeeder Pick-Up Roller

Releasing Solenoid (SL5)

Install the solenoid so that the distance be-
tween the solenoid arm [2] and the rear side plate
[3] is 3.5 ±0.2 mm when the plunger of the solenoid
[1] is pushed in.
COPYRIGHT © 2001 CANON INC.
[1]
A
B
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
[2]
3.5±0.2mm
[3]
Figure 7-257 (rear)
15 Adjusting the Position of the

Duplexing Unit Pick-Up Roller

Releasing Solenoid (SL8)
1) Remove the pick-up assembly.
2) Lift the lever [1] as shown, and let the pick-up
roller [2] drop on its own weight.
3) Adjust the position of the solenoid so that the
distance L is 43 ±1 mm when the plunger is
pushed in.
Make adjustments while the pin [4] is
in contact with the bottom end of the
long hole.
[1]
L
[2]
[3]
[4]
Figure 7-258
[1]
7-31