Canon 1000 Service Manual page 697

DISP COUNTER
ADJUST
FUNC
OPTION
TEST
Entering Backup Data
If you have executed 'RAM-CLR' for the DC controller PCB, use this screen to enter the data recorded on
the label shown in Figure 7-702.
Item
P-TH-1/2 Enters the output characteristics of the paper thickness
sensor set at time of shipment from the factory.
SNSR-RNK Enters the characteristics (A to E) of the paper thick-
ness sensor to be installed newly.
Y/C/K-OFST Use it to enter the offset value for the image position
correction pattern.
POTOFSTYY/ Use it to enter the offset value for the potential sensor.
M/C/K
COPYRIGHT © 2001 CANON INC.
<M> <S>
DC-CON 5/5
P-TH-1 P-TH-2
XXXX XXXX
Y-OFST C-OFST
X
POTOFSTY POTOFSTM
XX XX
Description
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
<R> <P>
READY
SNSR-RNK
K-OFST
X X
POTOFSTC POTOFSTK
XX
<F>
A
XX
Remarks
The values A through E
change by toggle opera-
tion.
Do not enter any values
other than those on the
service data sheet.
7-261