Photosensitive Drum; Removing The Photosensitive Drum; Cleaning The Photosensitive Drum; Points To Note When Installing The Photosensitive Drum - Canon 1000 Service Manual

Color laser copier
Hide thumbs Also See for 1000:
Table of Contents

Advertisement

4. MECHANICAL SYSTEM
D. Photosensitive Drum
1. Removing the Photosensitive
Drum
1)
Remove the process unit from the copier, and
remove the developing assembly/cleaning
unit (See chapter 4. IX. PROCESS UNIT
SYSTEM, A-2. Removing the Developing
Assembly/Cleaning Unit).
2)
While holding both ends of the drum [1], lift it to
remove.
When removing the photosensitive
drum, take extra care not to damage
it.
Figure 4-901D

2. Cleaning the Photosensitive Drum

If the surface of the photosensitive drum is
soiled, clean it with a cloth coated with toner. (Do
not use paper, lint-free or otherwise.)
Do not dry-wipe or use solvent.
Do not use drum cleaning powder.
4-90
COPYRIGHT © 2001 CANON INC.
3. Points to Note When Installing the

Photosensitive Drum

Make sure that the two bosses [1] on the
inside of the flange shaft of the photosensitive
drum match the slits [2] in the drum shaft.
[1]
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
Figure 4-902D
Figure 4-903D
Slit and boss
matched.
[1]
Slit and boss

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000s3100

Table of Contents