Mounting The Developing Bias Assembly Protection Member - Canon 1000 Service Manual

G. Mounting the Developing Bias Assembly Protection Member
Step
1 Remove the M4x8mm screw used to
secure the power cord base in place.
2 Secure the developing bias protection
member (left side in the illsutration) to
the power cord base using the
M4x8mm screw removed in step1 as
shown. Using the M4x8mm screw used
to hold the rear cover, secure the
developing bias assembly protection
member to the rear of the base plate.
3 Lead the belt through the gap of the belt
retaining member. Before suspending
the machine, apply light tension, and
check to make sure that the belt is in
contact with the top surface of the
retaining member at four points.
COPYRIGHT © 2001 CANON INC.
Work
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Remarks
Screw
Hole
Developing bias assembly
protection member
5. INSTALLATION
Hole
5-21