E073; E074 - Canon 1000 Service Manual

21

E073

Cause Step
Transfer frame
drawer connec-
tor, DC controller
PCB
22

E074

Cause Step
Transfer belt
lifter sensor 1
(PS12), 2 (PS13)
Operation
(faulty)
Sensor (position)
Pick-up motor
Transfer belt
lifter clutch
(CL17)
DC controller
PCB
COPYRIGHT © 2001 CANON INC.
Checks
1 Is the transfer frame drawer connec-
tor soiled with toner or damaged?
Checks
1 Is the sensor normal? (See the
instructions on how to check
photointerrupters.)
2 Turn the transfer belt lifter drive shaft
by a finger. Does it turn smoothly?
3 Turn OFF and ON the power switch
to clear 'E074'.
Press the Start key, and check the
operation of the lifter of the transfer
belt by the eye. Does the transfer
belt move up and down?
4 Turn OFF and ON the power switch
once again, and press the Start key.
Does the pick-up motor rotate?
5 Turn OFF and ON the power switch
once again, and press the Start key.
Does the voltage between J2226A-5
and J2226A-4 on the DC controller
PCB change from 0 V to 24 V?
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Yes/No
YES
NO
Yes/No
NO
NO
YES
NO
YES
NO
Action
Clean and replace the
drawer connector.
Check the wiring from
J2218 on the DC control-
ler PCB to the transfer
frame drawer connector
J6122; if normal, replace
the DC controller PCB.
Action
Replace the sensor.
Remove the cause of the
faulty rotation.
Check the position of the
sensor; if normal, replace
the DC controller PCB.
Check the wiring; if
normal, replace the pick-
up motor.
Check the wiring from the
clutch to the DC controller
PCB; if normal, replace
the clutch.
Replace the DC controller
PCB.
7-113