Removing The Pick-Up Drive Assembly - Canon 1000 Service Manual

2. Removing the Pick-Up Drive
Assembly
1) Remove the rear cover 1/2 and the rear right
cover.
2) Disconnect the four connectors [1], and
remove the three screws [2]; then, remove the
pick-up motor driver PCB [3] together with the
support plate.
[3]
[1]
Figure 4-202C
COPYRIGHT © 2001 CANON INC.
[2]
[2]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
3) Loosen the two screws [4] to loosen the
tensioner plate [5]; then, detach the drive belt
[6].
[6]
[5]
[4]
Figure 4-203C
4) Remove the pick-up assembly.
5) Remove the screw [7] from the pick-up relay
PCB, and remove the two screws [8] from the
pick-up drive assembly.
[7]
[8]
Figure 4-204C
[4]
4-13