E013 - Canon 1000 Service Manual

6

E013

• Check the detail code of 'E013' using 'JAM/ERR' under 'DISPLAY' in service mode.
Cause Step
Waste toner
feeding screw
Waste toner
feeding motor
(M20)
DC controller
PCB
Waste toner lock
detecting switch
(M4)
DC controller
PCB
E013-0002
1) Turn off the power switch.
2) Apply vibration to area A of the waste toner box [1] so that the toner moves from the rear to the front.
COPYRIGHT © 2001 CANON INC.
Checks
1 Is '0002' indicated?
2 Set the meter to the 12VDC range.
Does the voltage between J2226A-2
(+) and J2226A-3 (–) on the DC
controller PCB change from 5 to 0 V
when the Start key is pressed after
turning off and then on the power?
3 Is the voltage between J2223B-10
(+) and J2223B-11 (–) on the DC
controller PCB 0 V when the waste
toner lock detecting switch is
pressed and 5 V when released?
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Yes/No
[1]
Figure 7-401
Action
YES The waste toner case is
full, imposing excess load
on the waste toner feed-
ing screw. Remove the
waste toner as shown
under "F013-0002."
YES Check the wiring; if
normal, replace the waste
toner feeding motor.
NO Replace the DC controller
PCB.
NO Replace the waste toner
lock detecting switch.
YES Replace the DC controller
PCB.
A
7-93