2. Points to Note When Installing the
Y Image Correcting Mirror Unit
Butt the Y image position correcting mirror
assembly [1] against the butting plate [2] to fix it in
position.
[1]
Figure 4-604B (rear)
[1]
Figure 4-605B (front)
COPYRIGHT © 2001 CANON INC.
[2]
[2]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
3. Removing and Installing the
Motors for the Y Image Correcting
Mirror
•
Removing the Tilt Correcting Motor (M2)
1)
Remove the Y image position correcting
mirror unit.
2)
Remove the two screws [1], and remove the
motor [2].
[1]
[2]
Figure 4-606B
•
Removing the Ratio Correcting Motor (M3)
1)
Remove the Y image position correcting
mirror unit.
2)
Disconnect the connector [1], and remove the
spring [2].
3)
Remove the two screws [3], and remove the
motor [4].
[1]
[3]
Figure 4-607B
[2]
[3]
[4]
4-65