Developing Drive Assembly; Removing The Developing Drive Assembly And The Developing Assembly Rail; Developing Drive - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM
K. Developing Drive
Assembly
1. Removing the Developing Drive
Assembly and the Developing
Assembly Rail
1) Remove all developing assemblies.
2) Remove the rear cover, right upper cover,
and right rear cover.
3) Remove the flywheel.
4) Disconnect the four connectors [1], and
remove the two screws [2]; then, detach
the potential measurement PCB.
5) Open the CPU PCB.
6) Remove the drive assembly reinforcing
plate.
7) While lifting the tension plate [3] by hand,
detach the drive belt [4].
8) Remove the two screws [6].
6-84
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[2] [1]
Figure 6-682
[3]
[4]
Figure 6-683
[6]
[6]
Figure 6-684
[2]