Supplying Toner - Canon 1000 Service Manual

C. Supplying Toner
Step
1 As if to invert the top and the bottom,
shake the Y toner container 20 times or
more.
Do not perform this step until
immediately before setting
the bottle to the hopper.
2 Open the lid of the Y toner hopper, and
fit the Y toner bottle in the opening of
the hopper; hold the base of the bottle,
and turn the bottle clockwise until it
stops (about 10°).
3 Pull the slide shutter of the Y toner
bottle toward the front, and lightly tap
on the bottom and the side of the bottle
two to three times.
• Take note of the time at which toner
supply operation starts.
• Check to make sure that the toner
has poured into the hopper.
4 Close the slide shutter of the Y toner
bottle, and turn the bottle
counterclockwise (about 10°) to
remove.
Check to make sure no toner remains
on the mesh over the inlet to the
hopper; otherwise, tap on the hopper
until all toner has fallen into the hopper.
COPYRIGHT © 2001 CANON INC.
Work
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
5. INSTALLATION
Remarks
Slide shutter
5-7