Selecting The Site - Canon 1000 Service Manual

I. SELECTING THE SITE
Select the site of installation with the following
considerations in mind; if possible, pay a visit to the
user's before delivering the machine.
1. Make sure that the power supply enables
exclusive connection to a receptacle rated as
follows, and the appropriate terminal of the
receptacle is properly grounded for safety:
Mode Voltage
1 North American 208/240 V*
2 European 230 V
3 UK 230 V
4 Australian 230 V
*Set to 208V at time of shipment from the
factory; to change to 240V, be sure to use the
following voltage modification kit and replace
the heater and the wiring.
240V Voltage Modification Kit
Contents:
[1] 230V 650W upper heater .................. 1pcs
[2] 230V 550W lower heater .................. 1pcs
[3] 230V deck heater harness ................ 1pcs
[4] Label ................................................. 1pcs
650W
240V
This machine has been modified to 240V
for North America.
Figure 5-1
COPYRIGHT © 2001 CANON INC.
Amperage Receptacle
15 A NEMA 6-20R
16A DIN49440/49441
13 A BS1363
15 A AS
[1]
[2]
550W
[3]
[4]
FS6-8393
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
2. The temperature and humidity requirements
must be as shown in Figure 5-1. Avoid areas
near water faucets, water boilers, humidifiers,
or refrigerators.
Humidity (%)
90
80
70
60
50
40
30
20
10
0
5 10
Figure 5-2
3. Avoid areas near sources of fire and areas
subject to dust or ammonium gas. Avoid direct
rays of the sun; as necessary, provide
curtains.
4. The room must be well ventilated.
The level of ozone emitted by the
machine should not harm the health
of those around the machine. How-
ever, some may find the level un-
pleasant if the machine is used for a
long time in a poorly ventilated
room. Make sure the room is venti-
lated often.
5. The floor must be level so that all feet of the
machine are in contact with the floor and the
machine remains level.
5. INSTALLATION
15 20 25 30
5-1
C