Removing The Oil Applying Roller Blade; Removing The Oil Applying Roller; Opening The Oil Applying Roller Assembly - Canon 1000 Service Manual

4. MECHANICAL SYSTEM

2. Removing the Oil Applying Roller

Blade
1) Remove the oil applying roller blade unit.
2) Remove the four screws [1], and remove the
oil applying roller blade [2].
[1]
Figure 4-1002D
3. Removing the Oil Applying Roller
1) Remove the oil applying roller blade unit.
2) Remove the two E-rings (one each from front
and rear) [1].
3) Remove the gear* [2], and remove the two
bushings (one each from front and rear) [3].
*Pay attention to the parallel pin inside.
4) Remove the oil applying roller.
[1]
[3]
Figure 4-1003D
4-106
COPYRIGHT © 2001 CANON INC.
[2]
[1]
[3] [2] [1]
4. Opening the Oil Applying Roller
Assembly
When servicing the scoop-up roller assembly
found at the bottom of the oil applying roller,
work as follows:
1) Open the upper fixing roller unit.
2) Remove the screw [1] from the rear of the oil
applying roller assembly.
3) Loosen the screw [2] on the oil applying roller
assembly (front), and remove the screw [3].
4) Open the oil applying roller assembly [4] in the
direction of the arrow, and tighten the screw
[2] to fix in position.
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 4-1004D
[4]
Figure 4-1005D
[1]
[2]
[3]