Canon 1000 Service Manual page 680

7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
DISP COUNTER
ADJUST
FUNC
OPTION
TEST
Item
BODY °C Indicates the machine internal temperature measured
by the environment sensor.
BODY % Indicates the machine internal humidity measured by
the environment sensor.
BODY g Indicates the machine internal humidity absolute value
(g) measured by the environment sensor.
<<<ZONE-A>>> Indicates the zone in which the setting shown is effective.
TR-N1 Effective in plain paper mode and, in addition, when
copying on a one-sided copy or on the 1st side of a
two-sided copy.
TR-N2 Effective in plain paper mode and, in addition, when
copying on the 2nd side of a two-sided copy.
TR-OHP Effective in OHP mode.
TR-# Effective during image position correction control.
TR-T1 Effective in thick paper mode and, in addition, copying on
a one-sided copy or on the 1st side of a two-sided copy.
TR-T2 Effective in thick paper mode and, in addition, copying
on the 2nd side of a two-sided copy.
TR-UT1 Effective in extra thick paper mode and, in addition,
when copying on the 1st side of a two-sided copy.
TR-UT2 Effective in extra thick paper mode and, in addition,
when copying on the 2nd side of a two-sided copy.
TR-S1-1 Effective in special paper 1 mode and, in addition,
when copying on a one-sided copy or on the 1st side of
a two-sided copy.
TR-S1-2 Effective in special paper 1 mode and, in addition,
when copying on the 2nd side of a two-sided copy.
TR-S2-1 Effective in special paper 2 mode and, in addition,
when copying on a one-sided copy.
TR-S2-2 Effective in special paper 2 mode and, in addition,
when copying on the 2nd side of a two-sided copy.
TR-S3-1 Effective in thin paper and, in addition, when copying
on a one-sided copy or on the 1st side of a two-sided
copy.
TR-S3-2 Effective in thin paper and, in addition, when copying
on the 2nd side of a two-sided copy.
The setting of this item will return to the default value when the PCB is replaced or the RAM is cleared,
requiring input once again. Be sure to record any new setting you have made on the service label.
This mode will prove effective when correcting transfer faults under each item in question.
REF.
7-244
COPYRIGHT © 2001 CANON INC.
<M> <S>
HV-TR-Y 2/4
˚C
BODY xxx
BODY %
xxx
g
BODY xxx
<<<<<<< ZONE A >>>>>>>
TR-N1 TR-OHP
xxxx xxxx
TR-N2 TR-#
xxxx xxxx
Description
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
<R> <P>
TR-T1 TR-S1-2
xxxx xxxx
TR-T2 TR-S2-1
xxxx xxxx
TR-UT1 TR-S2-2
xxxx xxxx
TR-UT2 TR-S3-1
xxxx xxxx
TR-S1-1 TR-S3-2
xxxx xxxx
Same as the reading
under 'DISPLAY' >
'ANALOG'.
Settings: –5 to +5
Unit = 1.0 µA
Standard: 0
<F>
Remarks