Canon 1000 Service Manual page 555

Correcting E194-0001/0002
1) Turn off the power switch.
2) Open the front cover.
3) Remove the image position correction CCD unit. (See the descriptions under "Removing the Image
Position Correction CCD Unit" in Chapter 4.)
4) Remove the screw [2], and remove the support plate (front) [1].
5) Remove the screw [4], and remove the shutter [3]. (At this time, take care not to deform the grounding
plate [5]. Take care also not to lose the screw [4]; it is a special screw.)
6) With lint-free paper, dry wipe the top and bottom faces of the shutter [3], top and bottom faces of the
support plate (front) [1], and top and bottom faces of the support plate (rear) [6].
7) Dry wipe the LED [7] with lint-free papaer. At this time, do not apply excess force on the LED.
8) Install the shutter with a screw. (At this time, take care not to deform the grounding plate.)
9) Install the support plate (front) with a screw.
COPYRIGHT © 2001 CANON INC.
[2]
[1]
[3]
Figure 7-405
Figure 7-406
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
[4]
[7]
[5]
[6]
7-119