Transfer Unit; 1A. Removing The Transfer Blade; Iv. Transfer Unit - Canon 1000 Service Manual

4. MECHANICAL SYSTEM

IV. TRANSFER UNIT

A. Transfer Unit

1a. Removing the Transfer Blade

1) Open the front cover, and slide out the transfer
unit to the front.
2) Remove the two screws [1], and remove the
pre-transfer cover [2].
[1]
Figure 4-401A
3) While pulling the lever [3] on the bottom of the
transfer unit toward the front, set the transfer
releasing lever [4].
[4]
Figure 4-402A
4-42
COPYRIGHT © 2001 CANON INC.
[2]
[3]
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4) Turn the cam [5] by hand so that the belt unit
[6] is in up position.
5) Turn the knob [7] clockwise halfway, and pull
out the transfer blade assembly [8].
[1]
[8]
6) Turn the knob [7] counterclockwise halfway to
unlock, and remove the two screws [9], and
remove the transfer blade [10].
[9]
[6]
Figure 4-403A
[7]
Figure 4-404A
[10]
Figure 4-405Aa
[5]
[9]