Canon 1000 Service Manual page 689

Item
STIR-Y/M/C/K Stirs the developer of the specified color.
STIR-4 Stirs the developers of the four colors at the same time.
SPLY-Y/M/C/K Rotates the cylinder of the developing assembly to
supply developer of the specified color.
IMG-REG Turns on or off the image position auto correction
function.
0: OFF
1: ON
LSNS-KIL Turns on or off the toner sensor output mode for
moving up/down the hopper.
0: OFF
1: ON
NLSET-K Use it to suppress fogging of Bk, if noted in a low-
humidity environment, as follows:
1. In the environment in question, check to make sure
2. Replace the Bk developer. (See chapter 7. II. Stand-
3. Execute 'FUNC>INSTALL (2nd page)>NLSET-K' in
4. Check to make sure that 'PASCAL' in
5. Execute auto gradation correction in user mode.
REG-APER Executes auto correction of the read-in coordinates of
the image position correction pattern.
RECV-Y/M/C/K Rotates the cylinder of the developing assembly to
draw developer out of the developing assembly of the
specified color.
• Be sure to place the developer collecting container
RECV-4 Rotates the cylinders of the developing assemblies to
draw the developers out of the developing assemblies
for four colors.
WINCLR- Use it to read in the initial value of the window soiling
Y/M/C/K correctioncoefficient of a specific color.
WINCLR-4 Use it to read in the initial value of the window soiling
correction coefficient of the four colors.
COPYRIGHT © 2001 CANON INC.
Description
that the moisture content is 5 g (indicated as '500 g'
on the screen) or less.
ards and Adjustment, E.1 Replacing the Developer.;
however, do not execute auto gradation correction
as yet.)
service mode. (about 1 min)
'ADJUST>PASCAL' in service mode is '1'.
under the developer before opening of the developer
supply mouth.
This mode is NOT to be executed at time of
installation.
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
Remarks
Initial: 0
Used only at time of
installation.
7-253