Canon 1000 Service Manual page 28

1. GENERAL DESCRIPTION
Instructions to the User
1. When making two-sided copies in manual
mode, it is important to correct the curling on
the leading edge by reversing the direction of
the curl.
2. The transfer medium may be any of the
following seven types:
Plain paper: regular paper (80 to 105 g/
Thin paper:
Thick paper:
Extra thick paper: thicker than thick paper
Transparency: transparency film
Special paper 1: Paper identified as such on
Special paper 2: Paper identified as such on
3. Points to Note about Transparencies
• Avoid contact with the copying side, by
holding at the edge.
• Fan out each stack before setting it in a
cassette or the multifeeder.
• Remove from the tray immediately after
copying to avoid jamming.
• Keep unused transparencies in a box, and
store them avoiding high temperature and
humidity.
4. Points to Note about the Orientation of
Transparencies
• Orient each transparency so that it is fed in
the correct direction.
When Placing in a Cassette,
• If vertical, orient it so that the white triangle
at the corner is front left [1].
• If horizontal, orient it so that the white
triangle at the corner is front right [2].
[1]
Figure 1-405
1-16
COPYRIGHT © 2001 CANON INC.
m 2 )
paper thinner than plain
2
paper (64 to 79 g/m )
paper thicker than plain
2
paper (106 to 163 g/m
2
(164 to 209 g/m )
package
package
[2]
Placing on the Manual Feed Tray
• If vertical, orient it so that the white triangle is
front right [3].
• If horizontal, orient it so that the white
triangle is front left [4].
)
5. Cassette Sheet
In a high humidity environment, paper is likely
to become moist and will adversely affect
copying operation. If such is the case, advise
the user to place the cassette sheet on the
bottom of the cassette tray.
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
[4]
[3]
Figure 1-406