Figure 14: Leds On The Qsfp+ Uplink Ports; Table 6: Port Leds On A Qfx5100-24Q Switch - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide

Table 6: Port LEDs on a QFX5100-24Q Switch

Color State
Unlit Off
Green On steadily
Blinking
Amber Blinking
Related
Documentation
26

Figure 14: LEDs on the QSFP+ Uplink Ports

Table 6 on page 26 describes the SFP+ access port LEDs.
Field-Replaceable Units in a QFX5100 Device on page 12
Port Panel of a QFX5100-48S Device on page 28
Port Panel of a QFX5100-96S Device on page 32
Channelizing Interfaces
Access Port and Uplink Port LEDs on a QFX5100 Device on page 57
Installing and Removing QFX5100 Device Hardware Components on page 201
Connecting QFX Series Switches in a Virtual Chassis
Connecting a QFX5100 Device in a Virtual Chassis Fabric on page 187
Description
The port is administratively disabled, there is no power, or there is
a fault.
NOTE: When configured for channelized 10-Gigabit Ethernet, the
LED remains unlit only if all four of the 10-Gigabit Ethernet SFP+
breakout links are down.
A link is established, but there is no link activity.
NOTE: When configured for channelized 10-Gigabit Ethernet, the
LED is lit green when at least one of the four 10-Gigabit Ethernet
SFP+ breakout links is established.
A link is established, and there is link activity.
NOTE: When configured for channelized 10-Gigabit Ethernet, the
LED is lit green when at least one of the four 10-Gigabit Ethernet
SFP+ breakout links is established.
All four LEDs blink to indicate the beacon function was enabled on
the port.
Copyright © 2016, Juniper Networks, Inc.