Network Port Leds On Line Cards In An Ex9200 Switch; Table 16: Network Port Leds On Line Cards In An Ex9200 Switch-Link/Activity - Juniper EX9214 Hardware Manual

Network Port LEDs on Line Cards in an EX9200 Switch

Copyright © 2017, Juniper Networks, Inc.
Routing Engine Module in an EX9200 Switch on page 29
Switch Fabric Module in an EX9200 Switch on page 33
Each SFP, SFP+, QSFP+, CFP, and RJ-45 port on the faceplate of line cards has an LED,
the Link/Activity LED, which indicates the link status and activity on the port. Each RJ-45
port has an additional LED, the Status LED, which indicates the status of the port
parameters.
Table 16 on page 37 describes the Link/Activity LED.
Table 16: Network Port LEDs on Line Cards in an EX9200
Switch—Link/Activity LED
LED Color
Link/Activity Green
The Status LED in 10/100/1000BASE-T RJ-45 Ethernet network port indicates the status
of one of the three port parameters—administrative status, speed, and duplex mode
status.
Table 17 on page 38 describes the Status LED.
Chapter 2: Chassis Components and Descriptions
State and Description
On steadily—The port and the link are active,
but there is no link activity.
Blinking—The port and the link are active, and
there is link activity.
Off—The port is not active.
37