Removing A Virtual Chassis Module From An Ex4500 Switch; Figure 68: Installing The Virtual Chassis Module In An Ex4500 Switch - Juniper EX4500 Hardware Manual

Related
Documentation

Removing a Virtual Chassis Module from an EX4500 Switch

Copyright © 2017, Juniper Networks, Inc.
Reinstall the fan tray in the switch chassis. See
8.
Switch" on page 175.
Connect power to the switch. See
9.
page 141 or "Connecting DC Power to an EX4500 Switch" on page
When the status ( ST ) LED on the Virtual Chassis module turns green, the module is ready
for use.

Figure 68: Installing the Virtual Chassis Module in an EX4500 Switch

NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing a Virtual Chassis Module from an EX4500 Switch on page 215
Installing and Removing EX4500 Switch Hardware Components on page 132
The Virtual Chassis module is installed horizontally on the rear panel of the switch. See
"Rear Panel of an EX4500 Switch" on page
to remove the module from the switch chassis.
NOTE: The Virtual Chassis module is supported on EX4500 switches in Junos
OS Releases 11.1 and later.
CAUTION: Operating an EX4500 switch without the intraconnect module
or the Virtual Chassis module is not supported.
Chapter 23: Replacing Virtual Chassis Module
"Installing a Fan Tray in an EX4500
"Connecting AC Power to an EX4500 Switch" on
18. Use the procedure described in this topic
144.
. Failure
215