Installing The M120 Without A Mechanical Lift; Lift; Removing Components From The Chassis Before Installing The M120 Router Without A Mechanical Lift - Juniper M120 Hardware Manual

CHAPTER 18
Installing the M120 Without a Mechanical

Lift

Tools and Parts Required to Install the M120 Router Without a Mechanical Lift
Related
Documentation
Removing Components from the Chassis Before Installing the M120 Router Without
a Mechanical Lift
Copyright © 2018, Juniper Networks, Inc.
Tools and Parts Required to Install the M120 Router Without a Mechanical
Lift on page 129
Removing Components from the Chassis Before Installing the M120 Router Without a
Mechanical Lift on page 129
Installing the M120 Router Without Using a Mechanical Lift on page 139
Reinstalling Components in the Chassis After Installing the M120 Router Without a
Mechanical Lift on page 142
To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
3/8-in. nut driver
ESD grounding wrist strap
M120 Router Chassis Description on page 7
M120 Router Installation Summary on page 111
M120 Chassis Lifting Guidelines on page 321
General Safety Warnings for Juniper Networks Devices on page 314
Removing Components from the Chassis Before Installing the M120 Router Without a
Mechanical Lift on page 129
To make the router light enough to install manually, you first remove most components
from the chassis. The procedures in this section for removing components from the
chassis are for initial installation only, and assume that you have not connected power
129