Source
<url>
{image1 | image2}
image1
image2
{image1 | image2}
{image1 | image2}
Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time and date
by using SNTP.
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
Default
6
Format
sntp broadcast client poll-interval <poll-interval>
Mode
Global Config
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
no sntp broadcast client poll-interval
Mode
Global Config
Utility Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
Destination
{image1 | image2}
<url>
image2
image1
unit://<unit>/{image1 |
image2}
unit://*/{image1 | image2} Copy an image from the management node to all of the
v1.0, May 2010
Description
Download an image from the remote server to either
image. In a stacking environment, the downloaded
image is distributed to the stack nodes.
Upload either image to the remote server.
Copy image1 to image2.
Copy image2 to image1.
Copy an image from the management node to a given
node in a Stack. Use the unit parameter to specify the
node to which the image should be copied.
nodes in a Stack.
7-33