Tunnel Source; Tunnel Destination; Tunnel Mode Ipv6Ip; Show Interface Tunnel - NETGEAR GSM7228PS Cli Manual

tunnel source

This command specifies the source transport address of the tunnel, either explicitly or by reference
to an interface.
Format
tunnel source {<ipv4-address> | ethernet <unit/slot/port>}
Mode Interface Config

tunnel destination

This command specifies the destination transport address of the tunnel.
Format
tunnel destination {<ipv4-address>}
Mode Interface Config

tunnel mode ipv6ip

This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel mode
is set to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is configured.
Format
tunnel mode ipv6ip [6to4]
Mode Interface Config

show interface tunnel

This command displays the parameters related to tunnel such as tunnel mode, tunnel source
address and tunnel destination address.
Format
show interface tunnel [<tunnel-id>]
Mode Privileged EXEC
If you do not specify a tunnel ID, the command shows the following information for each
configured tunnel:
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
7-7