Show Interface Loopback - NETGEAR ProSafe GSM7224P User Manual

no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
Format
no interface loopback <loopback-id>
Mode
Global Config

show interface loopback

This command displays information about configured loopback interfaces.
Format
show interface loopback [<loopback-id>]
Mode
Privileged EXEC
If you do not specify a loopback ID, the following information appears for each loopback
interface on the system:
Term Definition
Loopback ID
The loopback ID associated with the rest of the information in the row.
Interface
The interface name.
IP Address
The IPv4 address of the interface.
Received
The number of packets received on this interface.
Packets
Sent Packets
The number of packets transmitted from this interface.
IPv6 Address
The IPv6 address of this interface.
If you specify a loopback ID, the following information appears:
Term Definition
Interface Link
Shows whether the link is up or down.
Status
IP Address
The IPv4 address of the interface.
IPv6 is enabled
Shows whether IPv6 is enabled on the interface.
(disabled)
IPv6 Prefix is
The IPv6 address of the interface.
MTU size
The maximum transmission size for packets on this interface, in bytes.
ProSafe Managed Switch
Switching Commands
45