Primed Version - Siemens SINAMICS G115D Operating Instructions Manual

11.1 General information geared motor with SINAMICS G115D Motor Mounted / Wall Mounted
Paint system
Corrosiveness category C5 for very high environmental stress
2-component epoxy zinc phosphate base coat,
2-component polyurethane intermediate coat,
2-component polyurethane top coat
In case of corrosiveness category C1, overpainting with a 1-component hydrosystem after
prior rubbing down is possible.
In case of corrosiveness categories C2 to C5, overpainting with 2-component polyurethane
paint, 2-component epoxide paint and 2-component acrylic paint after prior rubbing down is
possible.
11.1.4.3

Primed version

Table 11- 2
Paint system
Unpainted corrosiveness category C1
Cast iron parts immersion primed,
steel parts primed or zinc-plated,
aluminum and plastic parts untreated
Primed according to corrosiveness category C2 G
2-component epoxy zinc phosphate,
desired coat thickness 60 μm
Primed according to corrosiveness category C4 G
2-component epoxy zinc phosphate,
desired coat thickness 90 μm
SINAMICS G115D distributed drive
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
Primer according to corrosiveness category
Additional information on the SIMOGEAR geared motor
Description
• Indoor and outdoor installation
• Buildings and areas with almost constant condensa-
tion and high contamination, e.g. malt factories and
aseptic areas
• Industrial areas with high humidity and aggressive
atmosphere, coastal areas and offshore environments
with high salt levels
• Resistance to greases, mineral oils, aliphatic solvents,
sulfuric acid (10 %), caustic soda (20 %)
Can be overpainted with
• Synthetic paint, synthetic resin paint, oil paint
• 2-component polyurethane paint
• 2-component epoxy paint
• 2-component - polyurethane paint
• 2-component - epoxy paint
• 2-component - acrylic paint
• Acid-hardening paint
• 2-component - polyurethane paint
• 2-component - epoxy paint
• 2-component - acrylic paint
• Acid-hardening paint
389