Siemens SINAMICS G115D Operating Instructions Manual page 60

Distributed drive for conveyor technology control

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

4.7 Overview of the converter interfaces

Connection interface overview

The locations of the converter interfaces may vary depending on the variant ordered.

Motor-mounted converter

The figure below shows an example of PROFINET variant of the motor-mounted converter

with plug-in sockets:

Digital inputs DI 0 and DI 1 - X07

Digital inputs DI 2 and DI 3 - X08

Memory card interface

Bidirectional digital inputs/outputs DIO 24

and DIO 25 - X05

External braking resistor interface - X4

24 V DC power supply interface (OUT) - X02

24 V DC power supply interface (IN) - X01

Protective earth on the converter housing

PROFINET communication - X150 P1 and P2

(for PROFINET variant only)

Line supply interface (OUT) - X3

Line supply interface (IN) - X1

Fan unit connector (reserved)

Commissioning interface, including a mini-

USB interface and two electromechanical

potentiometers P1/P2

AS-i communication and auxiliary power -

X03 (for AS-i variant only)

Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002

SINAMICS G115D distributed drive