11.3
Specific data gearbox
11.3.1
General information gearbox
Note
Siemens AG does not accept any liability for damage and operational disturbances that result
from the non-observance of these operating instructions.
These operating instructions are part of the gearbox delivery. Store the operating instructions
near the gearbox. Please read the operating instructions prior to handling the gearbox and
observe the information they contain. This is how you ensure safe and disturbance-free
operation.
These operating instructions apply to the standard version of SIMOGEAR gearboxes:
• Helical gearboxes E, D and Z, frame sizes 19 to 89
• Parallel shaft gearboxes FD / FZ, frame sizes 29 to 89
• Bevel gearboxes B, K, frame sizes 19 to 89
• Helical worm gearboxes C, frame sizes 29 to 89
For a description of the precise designation see Gearbox type designation (Page 398).
Table 11- 29 Article number code
SIMOGEAR gearbox
Helical gearbox E
Helical gearbox D
Helical gearbox Z
Parallel shaft gearbox FD
Parallel shaft gearbox FZ
Bevel gearbox B, K
Helical worm gearbox C
Note
In addition to these operating instructions, special contractual agreements and technical
documentation apply to a special gearbox design and the associated supplementary
equipment.
Please refer to the other operating instructions supplied with the product.
SINAMICS G115D distributed drive
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
Additional information on the SIMOGEAR geared motor
Article number position
1
2
2
K
2
K
2
K
2
K
2
K
2
K
2
K
11.3 Specific data gearbox
3
4
5
J
8
0
J
8
2
J
8
1
J
8
4
J
8
3
J
8
5
J
8
6
437