Siemens SINAMICS G115D Operating Instructions Manual page 62

Wiring
4.7 Overview of the converter interfaces
Terminal layout of the Wiring Module
If you use the glanded variant of the converter, you must wire all the necessary terminals
inside the Wiring Module.
NOTICE
Device damage due to alteration to the factory connections
For the motor-mounted converter, the motor terminals inside the Wiring Module are already
wired up in the factory. Any alteration to the factory connections can result in device
malfunctions or damage.
• Do not alter the motor connections of the motor-mounted converter unless otherwise
The figures below give an overview of the terminals on the motor-mounted converter and
the wall-mounted converter respectively.
Note that the converters of glanded variant provide no cable glands but blanking caps at
delivery for all glanded interfaces.
Applicable glanded installation kits are available as optional components and can be ordered
with article numbers. For more information, refer to the following chapter:
Motor-mounted converter
① Line supply terminals - L1, L2, L3
② Motor power terminals - U, V, W
③ Digital inputs/outputs terminals - DI0~DI3,
④ Switched/unswitched 24 V power supply
60
explicitly instructed.
Glanded installation kit (Page 32)
DIO24, DIO25
terminals - 2L+, 2M / 1L+, 1M
Protective earth
⑤ DIP switches - DIP1, DIP2
⑥ Motor temperature sensor terminals - T+, T-
⑦ Braking resistor terminals - DCP, PB
⑧ 180 V DC EM brake terminals - EM+, EM-
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
SINAMICS G115D distributed drive