Siemens SINAMICS G115D Operating Instructions Manual page 59

Distributed drive for conveyor technology control

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

The Electronic Module is available in PROFINET variant, AS-i variant, and I/O control (without

fieldbus communication) variant. The Wiring Module is available in glanded variant and

connector variant.

The converter is equipped with plug-in sockets and/or blanking caps (for wiring with cable

glands) when delivered, depending on the variant, i.e. connector variant or glanded variant,

that has been ordered.

For the connector variant, the converter is all wired up internally when delivered and all that

is required is the external wiring of the system. For the glanded variant, make sure you wire

the terminals and route the cables inside the Wiring Module and fix with the cable glands.

Note that the converters of glanded variant provide no cable glands but blanking caps at

delivery for all glanded interfaces.

SINAMICS G115D distributed drive

Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002

4.7 Overview of the converter interfaces