Siemens SINAMICS G115D Operating Instructions Manual page 352

Corrective maintenance
9.5 Local/Remote control panel
Key/button
Inch-
ing/continuous
Jog left
Jog right
Parameters
With parameter r8559, you can read the feedback signal of the LRC panel status:
Parameter
r8559[0...12]
Further information
For more information on the "JOG" function, refer to the following chapter:
For more information on LRC functions, refer to function diagram 2507 of List Manual:
350
Description
This button toggles between inching and continuous movement of the motor.
movement of the motor is determined by the values set in parameters p1058 and p1059.
Inching: Press and hold the Jog button to run the motor, and release the button to
stop the motor.
Continuous: Press the Jog button to run the motor, and press the Jog button again
to stop the motor.
Pressing the Jog left button will move the conveyor belt to the left.
Pressing the Jog right button will move the conveyor belt to the right.
Description
Display and BICO output for the status of local/remote control panel.
• Bit 0: 1 = LRC is available.
• Bit 1: 1 = LRC is switched to OFF.
• Bit 2: 1 = Remote control is active.
• Bit 3: 1 = Local control is active.
• BIt 4: 1 = Quick stop override is active.
• Bit 5: 1 = Inching/continuous motion is active.
• Bit 6: 1 = Jog left is active
• Bit 7: 1 = Jog right is active
• Bit 8: 1 = LRC is not available. The LRC panel or the blanking cover is removed.
• Bit 9: Reserved
• Bit 10: 1 = LRC not detected. Unknown status is detected.
• Bit 11: 1 = Drive is inhibited. The drive is inhibited with bit 8=1 or bit10=1.
• Bit 12: 0 = repair switch is switched to ON; 1 = repair switch is switched to
OFF (mains on or no repair switch installed)
Jogging (Page 173)
Overview of the manuals (Page 542)
The LRC panel is connected or the blanking cover is fitted.
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
The
SINAMICS G115D distributed drive