Mounting
1. Mount the SAM interface kit to the SINAMICS G120 Smart Access and fix the two tightening
screws to the prescribed torque (0.8 Nm, 0.6 lbf.in) by using a flat-bit screwdriver or a cross-
tip screwdriver.
2. Remove the commissioning cover (③) from the G115D converter by using an S12 hex nut
driver.
Note
Reattach the commissioning cover with a tightening torque of 2.5 Nm (22.1 lbf.in).
SINAMICS G115D distributed drive
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
3.3 Mounting the optional components
Mounting
43