Pulling Off The Shrink Disk; Cleaning And Lubricating Shrink Disks - Siemens SINAMICS G115D Operating Instructions Manual

Additional information on the SIMOGEAR geared motor
11.3 Specific data gearbox
11.3.15.3

Pulling off the shrink disk

Procedure
1. Successively release the clamping bolts ⑥ one after the other through a ¼ turn each time
using a wrench. Do not completely remove the bolts.
2. Withdraw the shrink disk from the hollow shaft.
Sizes 79 - 89:
If the outer ring does not come away from the inner ring, remove some of the clamping bolts
and insert them into neighboring forcing threads.
You have withdrawn the shrink disk from the hollow shaft.
11.3.15.4

Cleaning and lubricating shrink disks

Soiled shrink disks must be cleaned and regreased prior to fitting.
Shrink disks that have been released need not be disassembled and regreased before being
retensioned.
Procedure
1. Only grease the inner friction surfaces of the shrink disks. To do this, use a solid lubricant
with a friction coefficient of μ = 0.04.
2. Use a paste containing MoS
underneath the head.
Clean the shrink disk.
Table 11- 38 Lubricants for shrink disks
Lubricant
Molykote 321 R (lubricant paint) Spray
Molykote spray (powder spray)
Molykote G Rapid
Molykombin UMFT 1
Unimily P5
Aemasol MO 19 P
456
to grease the bolts, applying the paste to the thread and
2
Sold as
Spray or paste
Spray
Powder
Spray or paste
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
Manufacturer
DOW Corning
Klüber Lubrication
A. C. Matthes
SINAMICS G115D distributed drive