Memory Card → Converter - Siemens SINAMICS G115D Operating Instructions Manual
Distributed drive for conveyor technology control
Hide thumbs
Also See for SINAMICS G115D:
- Operating instructions manual (522 pages) ,
- Operating instructions manual (600 pages)
Table of Contents
Advertisement
Data backup and series commissioning
7.1 Transferring settings using a memory card
Transferring using Startdrive
Precondition
• A memory card is inserted in the converter.
• Connection between the PG/PC and converter has been properly established via a USB
cable or the fieldbus.
• You have installed the Startdrive commissioning tool on your PG/PC.
Procedure
1. Go online.
2. Proceed as follows to transfer converter settings to the memory card.
3. Wait until Startdrive reports that data backup has been completed.
You have backed up the converter settings to the memory card.
❒
Transferring using SINAMICS G120 Smart Access
You can use the SINAMICS G120 Smart Access to transfer settings. For more information on
the transferring process, see Section "Backup and restore" in the SINAMICS G120 Smart
Access Operating Instructions.
7.1.3
Memory card → converter
You can transfer parameter settings from a memory card to the converter by the following
methods:
• Automatic transfer
• Transfer with Startdrive
• Transfer with SINAMICS G120 Smart Access
308
Overview of the manuals (Page 542)
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
SINAMICS G115D distributed drive
Advertisement
Table of Contents
