Resetting The Safety Functions To The Factory Settings - Siemens SINAMICS G115D Operating Instructions Manual

Distributed drive for conveyor technology control

Hide thumbs Also See for SINAMICS G115D:

Table of Contents

Resetting the safety functions to the factory settings

Procedure with Startdrive

1. Go online with the converter.

2. Select the command as follows from the project tree:

3. Select the menu option as follows:

4. Click on the

5. Select the reset options as desired by setting the check marks in the following dialog box:

6. Enter the password for the safety functions and the resetting process starts.

7. Go offline with the converter after the reset finishes.

8. Switch off the converter power supply and wait until all LEDs on the converter are dark.

9. Switch on the converter power supply again.

You have restored the safety functions in the converter to the factory settings.

SINAMICS G115D distributed drive

Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002

Commissioning

5.6 Restoring the factory settings